Ribbed Belt

Ribbed Belt

Removing

- Remove front noise insulation by loosening fasteners - 1 -.





• Ignore items - 2, 3 and 4 -.

- Remove bolts - arrows - and remove coolant pipes to ATF cooler with coolant hoses - 1 through 4 - connected from lock carrier.





CAUTION!
Risk of destroying due to reversed running direction on a used ribbed belt.

• Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

- Pivot tensioning device in direction of - arrow - to relieve tension on ribbed belt.





- Remove ribbed belt and release tensioning device.

Installing

Installation is in reverse order of removal, note the following:

- Route ribbed belt - 2 - over belt pulley in the specified sequence.





1 Generator
3 Idler roller
4 Vibration damper
5 Tensioning roller

• When installing the ribbed belt, make sure it is seated correctly on the pulleys.

- Start the engine and check the running belt.