Removal and Replacement

Navigation System

=> [ Navigation System with CD Drive Control Module ]

Navigation System with CD Drive Control Module

Special tools, testers and auxiliary items required

• Radio Removal Tool (T10057)

• Fiber optic plier repair set (VAS 6223)

• Protective cap for cable connector (VAS 6223/9)

• If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine. Use the Vehicle Diagnosis, Testing and Information System (VAS 5051) to do so.

- Switch off all electrical consumers.

- Remove the key.

Removing

- Open left luggage compartment storage bin.

- Insert two clips of (T10057) into release slots of navigation system with CD drive control module (J401) until they engage. Points on the grip eyelets of tool face outward.





- Pull navigation system with CD drive control module out of mounting frame.

- Disconnect all connectors at navigation system with CD drive control module.

- Attach the (VAS 6223/9) - 1 - onto the MOST-Bus connector - 2 -.





- Remove (T10057) by pressing locking tabs on navigation system with CD drive control module.

Removing Mounting Frame

- Remove nut - 1 - (8 Nm) and bolt - 2 - (8 Nm).





- Remove bolts - arrows - (3 Nm) to separate frame from slide-in slot.

Installing

Mounting frame:

- Install in reverse order.

Control module:

- Connect all harness connectors.

- Slide navigation system with CD drive control module in until it engages in mounting frame.