Electronic Stabilization Program, Bosch 5.7
Electronic Stabilization Program, Bosch 5.7
Electronic Stabilization Program, Bosch 5.7, Component Overview
1 - ABS Hydraulic Unit (N55) with ABS Control Module (J104)
• The hydraulic control unit is comprised of the hydraulic unit and control module. => [ Hydraulic Unit and Brake Lines Assembly Overview ] Hydraulic Unit and Brake Lines Assembly Overview
• Do not disconnect connector (42-pin) before successfully completing self-diagnosis. Switch ignition off before separating connector.
• Component location: On hydraulic unit in engine compartment, left
• Removing and installing => [ Hydraulic Unit ] Service and Repair
2 - Brake Pressure Sensor 1 (G201)
• Attached to hydraulic subframe
• Removing and installing => [ Brake Pressure Sensor 1 ] Service and Repair
3 - ASR/ESP Button (E256)
• Component location: In center console
4 - Transverse Acceleration Sensor (G200) and Rotation Rate Sensor (G202)
• Combined in one housing
• Component location: Under center console extension
• Can be checked in "Guided Fault Finding" using Vehicle Diagnosis, Testing and Information System (VAS 5051)
• Observe installation instructions
=> [ Transverse Acceleration Sensor and Rotation Rate Sensor ] Service and Repair
5 - Traction Control Indicator Lamp (K86)
• Component location: In instrument cluster
• See Owner's Manual for further information
6 - ABS warning light (K47)
• Component location: In instrument cluster
• See Owner's Manual for further information
7 - Brake System Warning Lamp (K118) symbol
• Location in instrument cluster in Driver Information System
• See Owner's Manual for further information
8 - Parking Brake Pressure Switch (F234)
• Component location: In center console
• Removing and installing => [ Parking Brake Button ] Service and Repair
9 - Steering Angle Sensor (G85) with ESP
• Component location: Installed in coil ring with slip ring on steering column, refer to => Electrical Equipment 94 Removal and Installation
• Perform zero adjustment
Vehicle Diagnosis, Testing and Information System (VAS 5051)
10 - Wheel bearing/hub unit
• The ABS sensor ring is installed in wheel bearing
11 - Right/Left Rear ABS Wheel Speed Sensor (G44/G46)
• Can be checked in "Guided Fault Finding" with Vehicle Diagnosis, Testing and Information System (VAS 5051)
• Replacing => [ ABS Components, Rear Axle ] ABS Components, Rear Axle
12 - Data Link Connector (DLC)
• Component location: cover in driver footwell
13 - Brake Light Switch (F) and Brake Pedal Switch (F47)
• Removing and installing => [ Brake Lamp Switch ] Service and Repair
• Can be checked in "Guided Fault Finding" with Vehicle Diagnosis, Testing and Information System (VAS 5051)
14 - Wheel bearing/hub unit
• The ABS sensor ring is installed in wheel bearing
15 - Right/Left Front ABS Wheel Speed Sensor (G45/G47)
• Can be checked in "Guided Fault Finding" with Vehicle Diagnosis, Testing and Information System (VAS 5051)
• Replacing => [ ABS Components, Front Axle ] ABS Components, Front Axle
16 - Brake Fluid Level Warning Switch (F34)
17 - Tandem brake booster