Exterior Mirror Turn Signal Lamps
Exterior Mirror Turn Signal Lamps
Special tools, testers and auxiliary items required
• Pry lever (80 - 200)
• Protective gloves
Removing
CAUTION!
Risk of injury.
• Wear protective gloves.
• To protect the paint in the area around the mirror housing, tape it off with a soft cloth.
- Press mirror glass - 1 - out of mirror adjusting unit - arrow - using Pry Lever (80 - 200).
- Disconnect the mirror heating electrical connectors - 2 - and - 3 - on the rear side of the mirror glass - 1 -.
- Unclip the electrical connector from the bracket - 5 -, if applicable.
- Disconnect the electrical connector - 4 -.
- Remove the bolts - 4 - and - 5 -.
- Release the retaining tabs - 3 - in the - direction of arrow A -.
- Release the retaining clip - 1 - and remove the exterior rearview mirror housing from the cover - 2 - - B arrows -.
Vehicles with Audi side assist:
- Press the mirror adjusting unit down and pull the exterior rearview mirror housing - 1 - upward slightly.
- Disconnect the electrical connector - 2 - for the lane change assist warning lamp on the front side of the mirror adjusting unit mount - 3 -.
All Vehicles
- Press the mirror adjusting unit down and remove the exterior rearview mirror housing upward.
- Disconnect the electrical connector - 3 - for the exterior rearview mirror turn signal.
- Remove the bolts - 1 - and - 4 -.
- Tilt the turn signal housing - 2 - out of the exterior rearview mirror housing - arrow -.
Installing
• Tightening Specifications. Refer to => [ Exterior Mirror Turn Signal Lamp, Component Overview from 09.07 ] Exterior Mirror Turn Signal Lamp, Component Overview from 09.07.
Install in reverse order of removal, observing the following:
• The entire exterior mirror turn signal must be replaced if an LED is faulty.
- Insert the tip of the turn signal in the slit in the exterior rearview mirror housing - 3 - - arrow A -.
- Tilt the turn signal bulb housing - 4 - into the exterior rearview mirror housing - arrow B -. The locking tab - 2 - must engage in the mount - 1 -.
- Attach mirror glass at mirror adjusting unit and press on mirror glass.
• Only press on the center of the mirror.