Access/Start Authorization Switch E415, Removing and Installing

Access/Start Authorization Switch E415, Removing And Installing

NOTE:
- If Access/Start Authorization Switch E415 is replaced, it is not necessary to adapt immobilizer.
- Lock in Access/Start Authorization Switch E415 is not mechanically coded.
- Therefore, when Access/Start Authorization Switch E415 switch is replaced, key must not be replaced. Existing keys continue to work.

Special tools, testers and auxiliary items required







- Wrench T10152







Removing


- Switch off ignition and remove ignition key.

CAUTION: Follow safety precautions when working on knee airbag.

- Remove drivers storage compartment.
- Use small screwdriver to pry off trim ring at Access/Start Authorization Switch - arrow -.







- Remove nut at Access/Start Authorization Switch E415 using Socket tool T10152.
- Take switch to rear out of drivers storage compartment.







Installing

Install in reverse order of removal, observing the following:
- Observe installation position of Access/Start Authorization Switch E415 with respect to drivers storage compartment.
- Lug - 1 - facing upwards
- Hand-tighten nut using Socket tool T10152.
- Observe installation position of trim ring at Access/Start Authorization Switch.
- Lugs - 3 - must engage in recesses - 2 - at switch.
- Install drivers storage compartment.