Sunroof / Moonroof: Adjustments

Glass Sunroof Panel, Adjusting

Checking The Gap Adjustment

• Check all the dimensions for the height adjustment from the center of the vehicle.

• The panels to body and to each should not be higher or lower than roof at any point.

- Perform height adjustment at front and rear according to illustration to prevent wind noise.






- Adjust the front and rear glass panels 1 according to dimensions - a - and - b -.

- Adjust the height of the panel 2 using the washer in the front corner.

- Adjust the rear panel 2 according to dimension - c -.

• Dimension - a - = -1 mm = / - 0.5 mm.

• Dimension - b - = 0 mm + 0.5 mm

• Dimension - c - = 0.5 mm + / - 0.5 mm.

• Dimension - d - = mm +0.5 mm + / - 0.5 mm.

• Dimension - e - = 10 mm + / - 0.5 mm.

• Dimension- f - = 1.5 mm + / - 0.5 mm.

• Dimension- g - = 1.5 mm + / - 0.5 mm.

• Dimension - h - = 11 mm + / - 0.5 mm.

- Adjust the front and rear glass panels 3 to dimensions - c - and - d -.

Adjusting

- Loosen screws -1- to -3- several turns.






- After adjusting, tighten the screws is sequence 1, 2 and 3, refer to => [ (Item 4) Screws ] Service and Repair.

- Adjust the panels according to the listed dimensions.






- Adjust to dimension a = 11 mm on the left and right sides of the roof opening.