Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2007 >> Q7 Quattro (4LB) V6-3.6L (BHK) >> Repair and Diagnosis >> Heating and Air Conditioning >> Service and Repair >> Removal and Replacement >> Sensors >> Left Front Upper Body Outlet Temperature Sensor (G385)

Left Front Upper Body Outlet Temperature Sensor (G385)







Left Front Upper Body Outlet Temperature Sensor (G385)

• Installed only in vehicles with Comfort version A/C system

• Retaining plate - B - can then only be removed and installed with instrument panel installed when the bolts - C - are not tightened too tightly, refer to => [ Retaining Plate With Defroster Door Motor (V107), Left Side Vent Motor (V299) and Left Center Vent Motor (V110) ] Retaining Plate With Defroster Door Motor (V107), Left Side Vent Motor (V299) and Left Center Vent Motor (V110). Since on the other hand the connection of the lever on the control motors to the levers on the doors cannot be checked with the instrument panel installed, it makes sense to remove the instrument panel and remove and install the control motors with the retaining plate installed, despite the great amount of work involved to remove and install the installed control motor.






Removing

- Remove instrument panel..

- Remove retaining plate with control motors (V108) and (V158) => [ Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158) ] Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158).

- Remove retaining plate with control motors (V107) , (V299) and (V110) => [ Retaining Plate With Defroster Door Motor (V107), Left Side Vent Motor (V299) and Left Center Vent Motor (V110) ] Retaining Plate With Defroster Door Motor (V107), Left Side Vent Motor (V299) and Left Center Vent Motor (V110).

- Disconnect connector - B - from Left Front Upper Body Outlet Temperature Sensor - A -.






- Rotate Left Front Upper Body Outlet Temperature Sensor - A - approximately 90° in direction of arrow.

- Remove v - A - from heating & A/C unit.

Installing

- Check O-ring seal - D - for damage and proper fitting.

- Insert Left Front Upper Body Outlet Temperature Sensor - A - on proper side into heating & A/C unit mount - E -.

• An O-ring seal - D - is installed so that Left Front Upper Body Outlet Temperature Sensor fits without play in mount - E -.

- Connect connector - B - to Left Front Upper Body Outlet Temperature Sensor - A - and check routing of wire - E -.

- Install retaining plate with control motors (V107) , (V299) and (V110) => [ Retaining Plate With Defroster Door Motor (V107), Left Side Vent Motor (V299) and Left Center Vent Motor (V110) ] Retaining Plate With Defroster Door Motor (V107), Left Side Vent Motor (V299) and Left Center Vent Motor (V110).

- Install retaining plate with control motors (V108) and (V158) => [ Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158) ] Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158).

- Install the remaining removed components again in reverse order.

- Check the DTC memory for the Climatronic control module (J255) and erase any faults displayed if necessary using the Vehicle diagnosis, testing and information system VAS 5051 in the "Guided Fault Finding" function.

- Perform a basic setting and output diagnostic test mode on the A/C system using the Vehicle Diagnosis, Testing and Information System VAS 5051 in the "Guided Fault Finding" function.

pro multis · About Operation CHARM