Side Marker Lamp and Turn Signal Housing

Side Marker Lamp and Turn Signal Housing

Removing

• When installing, reinstall all cable ties that were loosened or cut during removal in the same locations.

- Switch off ignition and remove ignition key.

- Turn light switch into "0" position.

Vehicles Without S Line Equipment:






- Remove air intake grille - 1 - in upper part of bumper cover - arrow -.

Vehicles With S Line Equipment:






- Remove the brace - 1 - for the air inlet grille from the bumper cover in the sequence shown - arrows A through D -.

- Disengage the air inlet grille - 2 - at the spot identified with - arrow E -, move it the side and remove it from the upper part of the bumper cover.

All Vehicles






- Remove screws - arrows - and remove housing - 1 - from bumper cover.

- Disconnect electrical connectors - 1 - and - 2 -.






- Cut through cable ties - arrow -.

Installing






Install in reverse order of removal, observing the following:

- Insert housing in bumper.

• Guides - 1 - must engage in mounts on bumper cover - 2 - - arrow -.

• When installing, install cable ties at same location.

Tightening Specifications