Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• M8 x 50 bolt

Removing

Risk of destroying due to reversed running direction on a used ribbed belt.

• Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

- To release ribbed belt tension, rotate tensioner in direction of - arrow -.





Risk of destroying tensioner.

• Only install bolt for securing tensioner far enough so that ribbed belt can be removed.

- Secure tensioner with M8 x 50 bolt - arrow A -.

- Remove ribbed belt.

Installing

Installation is in reverse order of removal, note the following:

• Before installing ribbed belt, generator, A/C compressor and power steering pump must be securely installed.

- Route ribbed belt as follows:





1. Vibration damper

2. Coolant pump

3. Tensioner

4. Generator

5. Idler pulley

6. Air conditioner compressor

7. Power steering pump

• When installing ribbed belt, make sure it is seated correctly on the pulleys.

- Release tensioner by removing bolt.

- Check whether ribbed belt is routed correctly.

- Start engine and check whether ribbed belt runs correctly.