Engine Controls - MIL ON/EPC Light On P0016
24 08 532016008/2
November 18, 2008. Supersedes Technical Service Bulletin Group 24 number 07-18 dated October 16, 2007 for reasons listed below.
Vehicle Information
01 MIL on and EPC light on (DTC P0016 in ECM)
Condition
The customer may report:
- EPC light on and slightly reduced engine torque because vehicle is in E-Gas Safety Mode.
Only in combination with:
- MIL on and the following DTC in ECM data memory: DTC P0016 (Crankshaft Position - Camshaft Position - Correlation Bank 1 Sensor A)
The customer might also report:
- Excessive clacking or rattling noise from engine area - strongest in idle.
Technical Background
The condition might be caused by the correlation between the crankshaft and the camshafts being out of tolerance.
Production Solution
Not applicable.
Service
For the condition described in this bulletin, it is necessary to create a TACS ticket and to contact the Technical Assistance Center for further instructions.
Warranty
When procedure applies to vehicles under warranty, use the following:
WIN
SAGA
Required Parts and Tools
The Audi Technical Assistance Center's instructions determine which parts are required for the repair.
- Destroy and properly dispose of removed parts in accordance with local, state and federal/provincial environmental regulations.
Additional Information
All part and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Dept. and service manuals for the latest information.