Outer Door Sill Molding

Outer Door Sill Molding






1 Front Sill Panel Trim

• To remove from sill, warm with hot air gun if necessary.

• Vehicle must be at room temperature before installing sill panel strips.

• Adhesion surfaces must be free of dust and grease.

• If necessary, remove adhesive residue and clean adhesion surfaces with Cleaning Solution (D 009 401 04).

• Remove protective foil from sill panel strip.

• Position sill panel strip centered on centering tab.

• Press entire surface of sill panel strip onto sill.

• Vehicle wait time approximately 4 hours at room temperature.

2 Rear Sill Panel Trim

• Removal and installation same as with front sill panel strip.

3 Inner Door Seal

4 Double Sided Adhesive Tape

• Pull off protective foil before installing.