Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2007 >> Q7 Quattro (4LB) V8-4.2L (BAR) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Front Sport Seats >> Trim

Trim







Trim

Special tools, testers and auxiliary items required

• Engine and Gearbox Support (VAS6095)

• Seat Repair Stand (VAS6136)

Removing


Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components General Safety Precautions ] .

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Create photos or sketches of wire securing and routing.

- Mount the (VAS 6136) on the (VAS 6095).

- Attach the front seat to the (VAS 6136).

- Pry off clips - 7 - (quantity: 4) from face plate - 1 -.






- Remove the trim - 1 -.

Installing


Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components General Safety Precautions ] .

Install in reverse order of removal. Note the following:


Before handling airbag units (for example, when disconnecting the harness connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Route and secure wiring according to photos or sketches that were made.

- Ensure all connectors are engaged correctly.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.


Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the battery is connected.

- Switch on ignition.

- Connect the battery ground cable with the ignition turned on.

- If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.

- Memory seat: perform a basic setting for the backrest or seat after installing the seat in the vehicle using "Guided Fault Finding".

pro multis · About Operation CHARM