Seat Height Adjuster

Seat Height Adjuster

Special tools, testers and auxiliary items required

• Engine and transmission holder (VAS 6095)






• Fixture for seat repair (VAS 6136)






Removing

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

- Turn on the ignition.

- Turn on the ignition and disconnect the ground cable from the battery.

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove backrest adjustment wheel. Refer to => [ Backrest Adjusting Wheel ] Backrest Adjusting Wheel.

- Remove seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove tunnel side trim panel. Refer to => [ Sill Side Trim ] Sill Side Trim.

- Remove the bolt - 2 -.






- Remove seat height adjustment handle - 1 - from the seat height adjuster.

- Remove nut - 5 -.

- Remove bolts - 7 - (quantity: 2).

- Remove the bolt - 3 -.

- Remove retaining plate - 6 - from seat frame - 4 -.

Installation

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

Install in reverse order of removal. Note the following:

- Ensure retaining plate - 6 - is positioned at arrow position on seat frame.






Before handling airbag units (for example, when disconnecting the harness connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Ensure airbag connector (yellow) engages correctly.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the battery is connected.

- Switch on ignition.

- Connect the battery ground cable with the ignition turned on.

- If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again. Refer to Vehicle diagnostic tester.

Tightening Specifications