Seat Heating Element

Seat Heating Element

Removing






- Disconnect cover from upholstery. Refer to => [ Seat Pan Cover and Upholstery ] Seat Pan Cover and Upholstery.

- Cut the electrical wire - 3 - off directly at the old backrest heating element - 2 -.

- Disconnect the connecting wires for the seat and seat bolster heating surfaces - upper arrows -.

- Carefully loosen heating surfaces - A - and - B -, which are glued only along the edge, and remove them.

• The spacer fabric must not be damaged.

• The old heating surfaces - C and D - remain on the cushion - 1 - and will be covered over by the new heating element.

Installing

- Align new heating element on backrest cushion.

• Make sure the new heating element is affixed to the old heating element.

• Remove the protective foil off the heating element in the affixing sequence.

• When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.

- Bond the individual areas of the heating element in the sequence - A, B, C and D -.

- Route the connecting wires to the individual heating surfaces in the base of the gaps - arrows -.

- Pull the wire - 2 - through the slit in the cushion - 1 -.

Further installation is performed in the reverse order of removal.