Tools and Materials Available From Regional Sales Center or Importer

Tools And Materials Available From Regional Sales Center Or Importer







A/C service station (this illustration shows e.g. A/C service station V.A.G 1885, currently available A/C service stations V.A.G workshop equipment catalog).
- The operations "testing, extraction (recycling), evacuation, flushing and charging" are to be performed in line with the relevant operating instructions.
- The filters and dryers installed are to be replaced at the latest at the end of the period of use specified in the operating instructions and whenever the station has been drained (keep replacement filter to hand; available from equipment manufacturer, refer to operating instructions).
- Use can also be made of A/C service stations not described here V.A.G workshop equipment catalog.
- Currently available A/C service stations are equipped with a program for flushing the refrigerant circuit; the flushing equipment required for flushing is also included in delivery V.A.G workshop equipment catalog

NOTE:
- This A/C service station comprises the following standard components: Charging cylinder, pressure gauge set, vacuum pump, shutoff valves and charging hoses.
- One quick-release coupling each (for service connections on high and low-pressure side) is included in the scope of delivery of this A/C service station.
- Depending on version, a current vacuum di splay (LED) may appear after pressing the "Evacuate" button again.







Leak detector V.A.G 1796







Leak detection system VAS 6201







Puller for A/C clutch V.A.G 1719 (for "Zexel" compressor)







Adapter set refrigerant Circuit R 134a V.A.G 1785/1-10

Adapter for cleaning refrigerant circuit (flush with refrigerant R134a or blow through with compressed air and nitrogen).


A - 5/8 inches -18 UNF thread for conical seal
B - Union nut (for connection with O-ring) with thread

- M 18x1.5 V.A.G /1
- M 20x1.5 V.A.G /2
- M 24x1.5 V.A.G /3
- M 28x1.5 V.A.G /4







Adapter

A - 5/8 inches -18 UNF thread for conical seal
B - Threaded connection for O-ring

- M 18x1.5 V.A.G /5
- M 20x1.5 V.A.G /6
- M 24x1.5 V.A.G /7
- M 28x1.5 V.A.G /8







Valve adapter

A - 5/8 inches -18 UNF thread for conical seal
B - Internal thread with valve opener

- M 10x1.25 V.A.G /9 (for connections with valve on high-pressure side)
- M 12x1.5 V.A.G /10 (for connections on low-pressure side)

NOTE:
- A Schrader valve is screwed into connection - A -.
- A valve opener must be installed in the charging hose connection.
- Various adapters from adapter set are also part of the adapter case for VW/Audi passenger cars VAS 6338/1







Air conditioning adapter set V.A.G 1786
A Adapter with union nut V.A.G /1 (only for connections with small valve insert on low pressure side)
B Charging hose with union nut 5/8 inches -18 UNF (short version)
C Adapter with service connection V.A.G /2

NOTE: For connections with large valve insert (standard on "Zexel" compressors, gradual change to small valve insert as of 10.94), use is to be made of adapter V.A.G /10 (remove valve from adapter V.A.G /10 or install valve opener in charging hose - B -).