A/T - Fluid Leaks From Torque Converter Seal

32 08 01

2015969/4

11/5/2008. Supersedes Technical Service Bulletin Group 32 number 07-05 dated December 20, 2007 for reasons listed below.





Vehicle Information

32 Transmission leaking





Condition

Figure 1:

ATF leaking from torque converter oil seal.

Technical Background

Dust/dirt intrusion into the bell housing may damage the seal.

Production Solution

- Improved torque converter oil seal.

- Close-out caps installed in bell housing.

- Cover installed between transmission and starter motor.

Service

1. Replace the torque converter seal. (Refer to Repair Manual Gr.32.)

2. Snap close-out caps into openings at both sides of transmission bell housing.

3. Install starter motor cover during installation of the transmission.

Warranty

When procedure applies to vehicles under warranty, use the following:





SAGA

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to review or audit by Audi Warranty.





Required Parts and Tools

Additional Information

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.