Windshield Wiper Arms

Windshield Wiper Arms

Special tools, testers and auxiliary items required

• Windshield Wiper Arm Tool Set (T10369)

Removing

• If the windshield wiper motor is to be run during the work procedure, the hood must be closed, otherwise the voltage supply of the wiper motor will be interrupted.

- Switch on ignition.

- Operate one-touch wiping and let wiper arms run to end position.

- Switch off ignition and remove ignition key.

- Using a screw driver, pry cover caps off wiper arms.






Windshield Wiper, Driver Side:

- Remove the nut - 3 -.

• Ignore - items 1, 2, 4 and 5 -.

- Position the Puller (T10369/4) on the wiper arm - 1 - as illustrated.






- Mount the pressure piece on the wiper axle.

- Rotate the bolt - 2 - clockwise until the wiper arm is removed from the axle.

- Remove the wiper arm.

Windshield Wiper, Passenger Side:






- Loosen nuts - 1 - and - 6 - a few turns.

- Position the Puller (T10369/1) on the wiper arm - 4 - as illustrated.

- Position the thrust piece - 5 - on the wiper axle.

- Rotate the bolt - 3 - clockwise until the wiper arm is removed from the axle.

- Remove the nuts and remove the wiper arms - 2 - and - 4 -.

Installing

Install in reverse order of removal, observing the following:

- Adjust wiper arms, refer to => [ Windshield Wiper Arms, Adjusting ] Windshield Wiper Arms, Adjusting.