Knock Sensors 3 and 4, Checking

Knock Sensors 3 and 4, Checking

The following procedure is used to diagnose Knock Sensor 3 (G198) and Knock Sensor 4 (G199) which are controlled by Engine Control Module (ECM) 2 (J624).

Special tools, testers and auxiliary items required

• Multimeter.

• Wiring diagram.

Test requirements

• The mounting bolt of Knock Sensors tightened to 20 Nm.

• The Engine Control Module (ECM) 2 (J624) fuses OK.

• Battery voltage at least 12.5 volts.

• All electrical consumers such as, lights and rear window defroster, switched off.

• Vehicles with automatic transmission, shift selector lever into position " P" or "N".

• A/C switched off.

• Ground (GND) connections between engine/transmission/chassis OK.

• Ignition switched off.

Test procedure

- Perform a preliminary check to verify the customers complaint. Refer to => [ General Diagnosis ] General Diagnosis.

Start diagnosis

- Remove the Intake manifold. Refer to Fuel Injection and Ignition Repair Information.

• Before disconnecting the Knock Sensor electrical harness connectors, mark the component location.

- Disconnect Knock Sensor 3 (G198) - 8 - or Knock Sensor 4 (G199) - 1 - electrical harness connector.





Checking internal resistance

- Using a Multimeter, check the Knock Sensor terminals 1 to 2 for an internal short.





Specified value: infinite (Infinity).

If the specified value was not obtained:

- Replace the faulty Knock Sensor 3 (G198) or Knock Sensor 4 (G199). Refer to Fuel Injection and Ignition Repair Information.

If the specified value was obtained:

Checking wiring

If the manufacturers test box is being used. Perform the following step.

- Install the test box. Refer to Fuel Injection and Ignition Repair Information.

If the manufacturers test box is not being used. Perform the following step.

- Remove the Engine Control Module (ECM) 2 (J624 ). Refer to => [ Engine Control Module 1, Removing and Installing ] Engine Control Module 1, Removing and Installing.

- Using a Multimeter, Check the Knock Sensor electrical harness connector to the Engine Control Module (ECM) 2 (J624) electrical harness connector T60a for an open circuit.













Specified value: 1.5 ohms Max.

If the specified value was not obtained:

- Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).

- Check the wiring connection for damage, corrosion, lose or broken terminals.

- If necessary, repair the faulty wiring connection.

If no malfunction is found in the wiring and the resistance was not OK:

- Replace the faulty Knock Sensor 3 (G198) or Knock Sensor 4 (G199). Refer to Fuel Injection and Ignition Repair Information.

If no malfunction is found in the wiring and the resistance was OK:

- Replace the Engine Control Module (ECM) 2 (J624 ).

- Install the Intake manifold. Refer to Fuel Injection and Ignition Repair Information.

Final procedures

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] Diagnostic Mode 03 - Read DTC Memory.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Mode 04 - Erase DTC Memory.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] Monitors, Trips, Drive Cycles and Readiness Codes.

- End of diagnosis.