Headlamps

Headlamps

Removing

- Turn light switch to position "0".

CAUTION!
• Switch off all electrical consumers.

• Switch ignition off and remove ignition key.

- Remove front bumper cover Removal and Installation.

- Remove screw - 3 -.





- Loosen screws - 1 - and - 2 - (do not remove).

- Remove headlamp from body towards front.

- Disconnect electrical connection.

Installing

Install in reverse order of removal, noting the following:

- Check adjusting nut - 1 - of adjuster for freedom of movement - arrows -.





- Screw in adjusting nut as far as it will go, but do not tighten.

- Insert headlamp and tighten screws - 1... 3 - two complete turns.





- Install front bumper cover Removal and Installation.

- Align headlamp with body contours and front bumper cover (note gap widths).

- Tighten screws in sequence - 2 -, - 1 - and - 3 -.

• When screws are tightened the adjusting nut of the adjuster element automatically rotates against the mounting point of the headlamp housing and fixes it in place.

- Check gaps; if necessary, repeat procedure for installing headlamp.

- Following installation, check and adjust headlamps if necessary =>.

Tightening Specifications