Backrest Cover and Padding, Removing and Installing
Backrest Cover And Padding, Removing And Installing
1 - Backrest cover
Removing
- Remove seat.
- Remove the backrest.
- Remove both outer parts of belt guide.
- Pry grip channel at edge of backrest cover - 1 - all around out of guide at backrest - 6 -.
- In bending sections, grip channel is also secured using retaining clamps - 3 -, carefully remove retaining clamps.
- Carefully loosen seams of backrest cover from Velcro fastener at backrest cushion - 4 -
- Disengage lower retaining strip at pneumatic block - 5 -.
- Remove backrest cover.
Installing
Installation is reverse of removal.
2 - Belt guide, outer part
- Removing and installing
3 - Retaining clamps (8x)
- For grip channel of backrest cover
- Install in bended section of backrest
4 - Backrest padding
Removing
- Remove backrest cover - 1 -.
- Disengage flaps for backrest bolster inflation adjustment - 7 - at retaining bracket of backrest.
- Disconnect pneumatic hose to backrest bolster inflation adjustment.
- Remove backrest cushion from backrest.
Installing
Installation is reverse of removal.
5 - Pneumatic block
Removing
- Remove backrest cover - 1 -.
- Remove backrest cushion - 4 -.
- Carefully loosen bonding of pneumatic block from backrest.
- Swivel pneumatic block toward front at upper edge.
- Free up electrical wiring harness.
- Remove pneumatic block.
Installing
Installation is reverse of removal.
- If necessary, replace double adhesive tape Parts Catalog.
- Assignment of pneumatic block.
6 - Backrest
7 - Flap for backrest bolster inflation adjustment
- Disengage
Pry grip channel for backrest cover out of guide
- Starting at bottom, pry grip channel for backrest cover out of guide at backrest, using e.g. an awl - arrow -; lightly press together backrest cushion in order to release backrest cover.
Disengaging flap for backrest bolster inflation adjustment
- Swivel backrest bolster inward - arrow A - and disengage flaps - 1 - for backrest bolster inflation adjustment at retaining bracket - 3 - of backrest - arrow B -.
- Disconnect pneumatic hose - 2 - to backrest bolster inflation adjustment.
- Remove backrest cushion from backrest.