Seat Height Adjustment Unit

Seat Height Adjustment Unit

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)





• Engine and transmission holder (VAS 6095)





• Fixture for seat repair (VAS 6136)









1 Retaining Clip

2 Seat Height Adjustment Handle Lever

3 Seat Height Adjustment Unit

• Removing

- Remove seat. Refer to => [ Standard Front Seat ] Standard Front Seat.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Remove backrest adjustment wheel. Refer to => [ Backrest Adjusting Wheel ] Backrest Adjusting Wheel.

- Remove seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove side trim on sill side. Refer to => [ Side Trim, Sill Side ].

- Remove nut - 5 -.

- Remove bolts - 7 - (Qty. 2).

- Remove screw - 4 -.

- Remove seat height adjustment unit - 3 - and retaining plate - 6 -.

• Installing

To install, perform the steps used in removal in reverse order. When doing so, note the following:

- Make sure that the retaining plate - 6 - makes contact on backrest frame at location indicated by arrow.

- Ensure retaining clamp - 1 - is positioned on seat height adjustment handle lever - 2 -. Note installation position => [ Retaining clamp installation position ].

4 Bolt

• Tightening specification 8 Nm

5 Nut

• Tightening specification 12 Nm

6 Retaining Plate

7 Screws (Qty. 2)

• Tightening specification 8 Nm