Procedures

Exhaust System Components, Removing And Installing

NOTE:
- Replace gaskets and self-locking nuts.
- During installation, protective heat boots must be re-installed at the same location.
- All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
- After exhaust system repairs, make sure exhaust system is not under stress and is far enough from the body. If necessary, loosen double clamps and align mufflers and exhaust pipes so that there is adequate distance to vehicle body, and weight is evenly distributed among the exhaust hangers.
- Flex joint in front exhaust pipe must not be bent more than 10 degrees, otherwise it may be damaged.