Monitor Wire In Backrest

Rear Seat Entertainment System, Plus Blaupunkt, from MY 07

Monitor Wire in Backrest

• The lower backrest cover must be removed to remove and install the monitor wire for the multimedia display unit 1 (Y22).

- Switch off all electrical consumers.

- Remove the key.

Removing

- Remove the lower backrest cover.

- Remove multimedia display unit 1 in headrest. Refer to => [ Multimedia Display Unit 1 ] Rear Seat Entertainment System, High Alpine.

The monitor wire is routed in the headrest tube. If malfunctioning, the monitor wire at lower connector must be disconnected.

- Disconnect the connector on the black monitor wire at the bottom of the seat and remove the individual contacts on the connector housing.

- Remove cable clips along the wire routing in seat backrest - arrows -.





• It is advantageous for the subsequent routing of the new monitor wire to document (with photos or sketches) the wire routing in the seat backrest before removal.

The wire on the seat wiring harness is routed in the lower section of the seat.

- Remove all cable clips here.

- Remove the monitor wire - arrows - upward and out of the headrest.





Installing

The monitor wire is supplied without the lower harness connector.

- Guide the monitor wire - arrows - with the open end through the headrest.





- On the wire, mark the





Dimension a = 80 mm

and the

Dimension b = 230 mm

Dimensions represent the mounting points. Also see the old monitor wire.

- Secure the monitor wire at - dimension a - at top left spring - arrow 1 -.





- Form a loop and secure monitor wire at - dimension b - from behind on seat wiring harness - arrow 3 -.

- Secure the monitor wire to backrest plate - arrow 2 -.

- Pay special attention that the monitor wire from outlet of headrest tube up to mount - arrow 2 - can follow the adjustment movements of the active headrest without jamming or stressing.

- Continue routing monitor wire at backrest and seat wiring harness - arrows - up to harness connector of seat wiring harness.





After completing work on the seat, connect the 12-pin connector to the monitor wire.

Connector assignment, refer to => [ Monitor Cable beneath Seat Connector Assignment ] Rear Seat Entertainment System, Plus Blaupunkt, From MY 07.

- Perform further installation in reverse order.