Side Trim

Side Trim


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.





1 Bolt

• 1.2 Nm

2 Sill Side Trim

Removing

- Remove the seat. Refer to => [ Seat ] Seat.

- Secure the seat on the (VAS 6136). Refer to => [ Front Seat, Installing on VAS 6136 ] Front Seat, Installing on VAS 6136.

- Remove backrest adjustment hand wheel - 5 -.

- Remove seat height adjustment handle - 7 -. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove expanding clip - 6 -, press clamping pin through to the inside.

- Remove mounting bolt - 1 -.

- Remove side panel - 2 - at lower edge from retaining bracket on seat.

- Swing side panel upward at front edge.

- Remove side panel to side.

- Pull tab at rear of side panel out under backrest trim.

Installation

To install, perform the steps used in removal in reverse order.

3 Tunnel Side Trim

Removing

- Remove the seat. Refer to => [ Seat ] Seat.

- Secure the seat on the (VAS 6136). Refer to => [ Front Seat, Installing on VAS 6136 ] Front Seat, Installing on VAS 6136.

- Remove expanding clip - 4 -, press clamping pin through to the inside.

- Disengage retaining detent at rear side of side panel on tunnel side.

- Remove the trim.

Installation

To install, perform the steps used in removal in reverse order.

4 Spreader Clip

5 Hand Wheel for Backrest Adjustment

• Removing and Installing, refer to => [ Backrest Adjustment Hand Wheel ] Backrest Adjustment Hand Wheel

6 Spreader Clip

7 Seat Height Adjustment Handle

• Removing and Installing, refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle