Windshield Washer Fluid Reservoir, Vehicles Without Auxiliary Heating

Windshield Washer Fluid Reservoir, Vehicles without Auxiliary Heating

Special tools, testers and auxiliary items required

• Drip tray

Removing

- Switch off ignition and remove ignition key.

- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Remove the front section of the front right wheel housing liner.

- Remove fog lamp. Refer to => [ Fog Lamp, through 05.2008 ] Fog Lamp, Through 05.2008.

- Place a drip tray under the windshield washer fluid reservoir.






- Disconnect the electrical connector - 5 -.

- Loosen the wiring harness - 4 - from the mount on the washer fluid reservoir.

- Open the clamp - 6 - - right arrow - and disconnect the fluid line - 7 - from the washer fluid pump.

Vehicles with headlamp washer system

- Disconnect the electrical connector - 3 -.

- Open the clamp - 2 - - left arrow - and disconnect the washer fluid line - 1 - from the pump for the headlamp washer system.

All Vehicles






- Remove bolt - 3 -.

- Remove the nuts - 1 - and then remove the windshield washer fluid reservoir - 2 -.

Installing

Install in reverse order of removal, observing the following:

• Washer fluid hose must engage audibly into connection for washer fluid pump.

- Install fog lamp. Refer to => [ Fog Lamp, through 05.2008 ] Fog Lamp, Through 05.2008.

- Install the front section of the front right wheel housing liner.

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

Tightening Specifications