B-Pillar Trim Panel
B-Pillar Trim Panel
1 Threaded Sleeve
2 Bracket for Trim Panel
- Height positioning occurs via height stop on roof trim molding.
- Longitudinal positioning occurs via rear longitudinal stop, which must make contact on closed rear door for a correct assembly.
- After installation, break off longitudinal stop on specified break point of bracket.
3 Bolt
• 2 Nm
4 B-Pillar Trim Panel
- With rear door opened, slide trim panel into bracket - 2 -.
- Close rear door and align trim panel parallel to door frame.
- Secure trim panel with front bolt - 6 -.
- Open rear door and secure trim panel with rear bolt - 6 -.
5 Seal
6 Bolt
• 2 Nm
7 Grommet
- After removing cover - 8 -, a new grommet must be used for reinstallation.
8 Cover
- Press securing pin for cover into grommet - 7 - as shown.