Seat

Seat

• The S3 bucket seat does not have a side airbag. Therefore the electrical connector for the side airbag is provided in the vehicle wiring harness with a terminal resistance.

• The terminal resistance is a component of the wiring harness.


• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.





1 Front Seat

Removing

- Push front seat - 1 - fully upward and to the rear.

- Remove front bolts - 3 - (quantity: 2).

- Move seat forward.

- Remove rear bolts - 4 - (quantity: 2).

- Tip front seat - 1 - back.

- Disconnect electrical harness connectors. Refer to => [ Connectors, Disconnecting ] Connectors, Disconnecting.

- Remove seat.

Installation

To install, perform the steps used in removal in reverse order.

2 Seat Rail Covers

• Removing and Installing, refer to => [ Seat Rail Covers ] Seat Rail Covers

3 Front Bolts

Quantity: 2

• 50 Nm

4 Rear Bolts

Quantity: 2

• 50 Nm