Cross-Member: Diagrams

Part I, Subframe - front wheel drive





1 - Subframe

2 - Plastic insert

^ Part of purchased bushing assembly

3 - Washer

^ Always replace

4 - Combi-bolt

^ Always replace
^ Tighten to 110 Nm plus an additional 90 degrees turn
^ Threads in body can be repaired according to DIN 8140 using wire thread inserts (Heli-Coil). Thread insert must be same length as thread in body.

5 - Washer

^ Front only
^ Corrugation face toward body
^ Only installed with hydraulic mounting 8E0 505 145 AQ
^ Discontinued from KW 48/00 with introduction of new hydraulic bushing