Rearview Mirror - Assembly Overview

Rearview Mirror - Assembly Overview

Special tools, testers and auxiliary items required







- Pry lever 80-200







1 - Mirror glass
- Use Pry Lever 80-200 to unclip.
- Protect mirror housing against damage using textile tape above and below.
- Press mirror lens first downward, then upward.
- to install mirror lens into guide pins and friction finger, insert into friction spring and press on.
- Apply pressure only on center of glass, wear protective gloves while doing so.

2 - Mirror heating connector
3 - Mirror adjusting unit
4 - Adjusting motor
- Removal

5 - Mirror housing
- May be removed from door without removing entire exterior rearview mirror.

6 - Electrical connection
- Clip into mirror glass on rear side.