Connectors, Disconnecting

Power Front Memory Seats

• From 06.2006, the usual wiring harness routing to connector station under front seat. Refer to => [ Connectors, Disconnecting ] Front Seats has been replaced with modular wiring routing => [ Modular Wiring Routing Assembly Overview, from June 2006 ] Front Seats.

• The modular wiring routing has not been implemented for all countries.

• Check version of front seat and of vehicle and perform repairs accordingly.

• Note the two possible versions of the modular wiring routing, Modular Light or Modular. Refer to => [ Modular Wiring Routing Versions ] Front Seats.

Connectors, Disconnecting

• Before disconnecting ignition and ground wiring, technician must electrostatically discharge him/herself (touch door striker plate or pin briefly).





1 - Front Seat

2 - Belt Buckle Sensor Connector (Black)

3 - Seat Heating Connector (Green)

4 - Current Supply Connector (Red)

5 - Airbag Connector (Yellow)

6 - Connector Point Cover

• Removing

- Tip front seat - 1 - back.

- Remove coupling station cover - 6 - upward.

- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.

- Connect the airbag adapter. Refer to => [ Airbag Adapter, Connecting ].

- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.

- Press in tab on airbag connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.

- For vehicles with seatbelt fasten sensor: Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.