All Wheel Drive

Rear Brake Rotor

Removing

- Raise the vehicle.

- Remove the wheel and tire.

- Remove the brake caliper.

- Support the brake caliper on the body.

- Inspect the rotor for signs of damage or dirt.

- If rotor is damaged, remove drive axle with rotor and replace outer joint.

- Removing and installing the drive axle. Refer to =>
Suspension Suspension

Installing

Installation is in the reverse order of removal.

- Route the speed sensor wire back in original position.

- Before installing, lubricate the speed sensor seal all around with lubricating paste (G 000 650).

• If the rotor is damaged or dirty, remove the drive axle. If damaged, replace outer Constant Velocity (CV) joint together with rotor.

• The outer CV joint is supplied as a replacement part with the rotor.