Oil Pressure Switch (For Fuel Pump): Service and Repair

Oil Pressure Switch, Removing and Installing

Removing





- Remove rear engine cover - arrows -.





- Remove coolant expansion tank - arrow -.
- Disconnect electrical connection from Engine Coolant Level (ECL) Warning Switch F66 at bottom of coolant reservoir and set aside coolant reservoir with coolant hoses -1- and -2- connected.

Note:
^ Place a rag under oil filter housing to catch escaping engine oil.





- Disconnect electrical harness connector from Oil Pressure Switch F1 - arrow -.
- Unscrew oil pressure switch.

Installing

Installation is in reverse order of removal, noting the following:

Note:
^ Replace seal.

- Check oil level.

Tightening Specifications