Air Cleaner Housing: Service and Repair

Air Filter Assembly Overview





1 Not installed

2 Air guide hose

• To turbocharger

• Check the air duct hose for dirt and leaves

3 Hose clamp

4 Mass air flow (MAF) sensor (G70)

• Removing and installing, refer to => [ Mass Air Flow Sensor ] Service and Repair

5 Bolt

• 1.5 Nm

6 Air duct

• To lock carrier

7 Bolt

• 1.5 Nm

• On lock carrier

8 Air duct

• To air filter housing

• Clean the air channel of debris and leaves

9 Spreader clip

10 Bolt

• 1.5 Nm

11 Upper part of air filter housing

• Clean air filter housing-upper part of salt residue, dirt and leaves

12 Heat shield

13 Bolt

• 1.5 Nm

14 Air filter element

• Always use a genuine air filter element

• Removing and installing, refer to => [ Air Filter Element ] Service and Repair

• Observe change intervals,

15 Lower part of air filter housing

• Clean the air filter housing-lower part of salt residue, dirt and leaves

• Using pressurized air, blow out the water drain (small hole) in the lower part of the air filter housing.

16 O-ring

• Replace if damaged

17 Not installed