Disconnecting Harness Connectors

Disconnecting Harness Connectors

CAUTION:
- Observe safety precautions for work on airbags Airbag Safety Precautions.
- Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.







1 - Front seat
2 - Belt buckle sensor connector (black)
3 - Seat heater connector (green)
4 - Current supply connector (red)
5 - Airbag connector (yellow)
6 - Panel or cover
- For connector station

Removal
- Tip front seat - 1 - back.

Vehicles without modular wiring routing through 08.05
- Remove connector station cover - 6 - upward.

Vehicles with modular wiring routing from 08.05
- Remove connector station cover.

Procedure for all vehicles
- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.
- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.
- Press in tab on connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.
- For vehicles with seatbelt fasten sensor: Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.
- Connect airbag adapter.

Installing
- Installation is reverse of removal.