Function 05 - Erasing DTC Memory

Function 05 - Erasing DTC Memory

- With the ignition switched off, connect Diagnostic Operation System VAS 5051A using, Diagnostic Cable - 3 Meter VAS 5051/5A and K-Lead Adapter VAS 6017B (or K-Lead Adapter VAS 6017A) to the 16-pin diagnostic socket in the vehicle. On Board Diagnostic Procedure
- Switch ignition on.
- Use address word "08" to select A/C heater electronics. On Board Diagnostic Procedure

Requirements:
- DTC memory checked. Function 02 - Check DTC Memory







Indicated on display of Diagnostic Operation System VAS 5051A :
- Select function "05 - Erasing DTC memory".

Indicated on display of Diagnostic Operation System VAS 5051A :







- There is no display in zone - 1 -.
- A box appears in display zone - 2 - with a message indicating that touching OK key will erase data (of fault memories) and requiring confirmation that function must be implemented.

NOTE:
- If display zone - 1 - indicates "DTC memory not yet checked", check DTC memory and rectify any faults.
- The DTC memory is not erased if, for example, the ignition is switched off between checking and erasing the DTC memory.

- On display of Diagnostic Operation System VAS 5051A, touch "O.K." box in zone - 2 -.

As soon as the DTC memory has been erased, zone - 1 - displays the message "DTC memory erased".

- On display of Diagnostic Operation System VAS 5051A, touch box with arrowleft key.