Parking Lamp Bulb, From MY 2007

Parking Lamp Bulb, from MY 2007

Removing





- Switch off ignition and remove ignition key.

- Turn light switch into "0" position.

- Remove screws - arrows -.

- Disengage Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80) - item 1 - at air duct.

- Remove air duct - 2 -.

- Release spring clip - arrow - and remove high beam/parking lamp housing cover from headlamp housing.





- Remove bulb - 1 - from spring clips - arrows -.





• Disregard item - 2 -.

- Remove parking lamp socket - 1 - from housing - arrow -.





- Pull light bulb for parking lamp out of socket.

Installing

Install in reverse order of removal, observing the following:

- Insert new bulb into socket, do not touch glass cone with bare hands when doing so.

- Press parking lamp socket into reflector until you feel it engage.

- Place high beam bulb on lower spring clip.

- Press high beam bulb in housing over upper spring clamp resistance.

- Close the housing lid.

- Secure housing cover using wire clamp.