Scuff Plate: Service and Repair

Rear Cross Panel Trim, Removing and Installing

Special tools, testers and auxiliary items required







- Torque wrench V.A.G 1410







1 - Screws (4x)
- Tightening torque 5 Nm

2 - Rear cross panel trim

Removal:
- Open luggage compartment floor lid.
- Remove screws - 1 - (Qty. 4).
- Carefully remove rear cross panel trim - 2 - from locking pins - arrows -.

Installing:
- Installation is reverse of removal. Observe the following when doing so:
- Rear lid rubber must lie over rear cross panel trim.
- Tighten screws to 5 Nm.