Triple Roller Joint

Component, overview

Grease quantity and type

Filling outer joint with grease G 000 603.

Filling triple roller joint with grease G 000 605.





Grease joint again when replacing protective joint boot.





1 - Bolt

^ Always replace if removed
^ Loosen
^ Fastening
^ Torque specification.

2 - Clamp

^ Replace

3 - Constant velocity (CV) joint boot

^ Check for tears and chafing
^ Before clamping hose clamp, raise protective joint boot briefly to balance pressure.

4 - Clamp

^ Replace

5 - Multi-point socket head bolt

6 - Triple roller joint housing
7 - Triple rotor star with rollers

^ Chamfer - arrow - faces splines drive axle splines
^ When installing triple roller star on profile shaft, profile shaft splines must be lightly coated with grease used in joint.

8 - Circlip

^ Replace

9 - O-ring

^ Replace

10 - Cover

^ Replace

11 - Clamp

^ For triple roller joint
^ Replace

12 - CV boot for triple roller joint

^ Check for tears and chafing
^ Before clamping hose clamp, raise protective joint boot briefly to balance pressure. Joint must be in center position.

13 - Axle shaft
14 - Circlip

^ Replace
^ Insert in shaft groove

15 - Outer constant velocity joint

^ Replace only as a unit
^ Installing: Drive onto shaft using plastic hammer until compressed circlip seats.
^ Greasing
^ When installing joint on profile shaft, profile shaft splines must be lightly coated with grease used in joint.