Low Fuel Pressure Sensor, Checking

Low Fuel Pressure Sensor, Checking

Special tools, testers and auxiliary items required
- Multimeter.
- Wiring diagram.

Test requirements
- The Fuel Pump (FP) Control Module J538 OK.
- The Engine Control Module (ECM) J623 fuses OK.
- The fuel filter OK.
- The battery voltage at least 12.5 V.
- All electrical consumers switched off (radiator fan must NOT run during test).
- A/C switched off.
- The fuel tank at least 1 / 4 filled.
- The ignition switched off.

Test procedure
- Perform a preliminary check to verify the customers complaint. General Diagnosis

Start diagnosis







- Remove the front engine cover - arrows -.

Checking voltage







- Disconnect the Low Fuel Pressure Sensor G410 electrical harness connector - 1 -.
- Switch the ignition on.







- Using a multimeter , check the Low Fuel Pressure Sensor G410 electrical harness connector for voltage.
- Switch the ignition off.

If the specified values are obtained:
- Replace the Low Fuel Pressure Sensor G410 , note the following:

NOTE: The 3.2L 6-Cyl. 4V (BKH) engine is equipped with two different Low Fuel Pressure Sensors G410 designs. One design is integrated into the high pressure fuel pump and must be replaced as a complete assembly. The second design is not integrated into the high pressure fuel pump and may be replaced separately.

If the specified values are not obtained:

Checking wiring

If the manufacturers test box is being used. Perform the following step.
- Install the test box.

If the manufacturers test box is not being used. Perform the following step.
- Remove the Engine Control Module (ECM) J623.







- Using a Multimeter , check the Low Fuel Pressure Sensor G410 electrical harness connector terminals to the Engine Control Module (ECM) J623 electrical harness connector T60 terminals for an open circuit according to the wiring diagram.

Low Fuel Pressure Sensor Engine Control Module (ECM)
G410 electrical harness J623 electrical connector T60
connector terminals terminals or test box socket
1 40
2 49
3 29

Specified value: 1.5 Ohms Max.

If the specification was not obtained:
- Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
- Check the electrical harness connector for damage, corrosion, lose or broken terminals.
- If necessary, repair the faulty wiring connection.

If no malfunction is detected in the wiring:
- Replace the Engine Control Module (ECM) J623.







- Install the front engine cover - arrows -.

Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase the DTC memory. Diagnostic Mode 04 - Erase DTC Memory
3. If the DTC memory was erased, generate readiness code. Monitors, Trips, Drive Cycles and Readiness Codes

- End of diagnosis.