Self-Adjusting Clutch, Sachs

Self-Adjusting Clutch, Sachs

Special tools, testers and auxiliary items required

• Retainer (3067)

• Centering Mandrel (3176)

• Counter Hold Tool (10 - 201)

• Grease for Clutch Disc Shaft Splines (G 000 100 )

- To loosen the bolts, install Flywheel Retainer ( 3067) or Counter Hold Tool (10 - 201).





When removing, loosen the bolts as follows, so that the pressure plate does not distort (causing shuddering on acceleration):

- Loosen all 6 bolts clockwise one after the other in stages of 90° (1/4 rotation) until pressure plate is free.

• When removing, the stop - 2 - must loosen together with the position sensor - 1 -.





Installing

• Clutch plate installation location: Spring pack (coil springs) or marking " Getriebeseite" must face pressure plate and transmission.

- Change from Flywheel Retainer (3067) to Counter Hold Tool (10 - 201) for removing.





- To center clutch plate, use Centering Mandrel (3176).

When installing, fasten bolts as follows, so pressure plate does not distort (causing shuddering on acceleration):

- Press pressure plate on alignment pin.

- Make sure the position sensor is easy to move - arrow -.





- Screw in all 6 bolts evenly, by hand, until the bolt heads contact the pressure plate.

- Tighten all 6 bolts clockwise one after the other in stages of 90° (1/4 rotation) until housing comes in contact with flywheel.

- When doing this, the position sensor - arrow - must lift off from the pressure plate.

- Tighten all 6 bolts clockwise one after another to 22 Nm.