Stone Chip Protective Molding

Stone Chip Protective Molding

• The stone chip protective molding is also secured to the side member using adhesive strips.

• It is not possible to remove without destroying.

• The clips are destroyed when removing the stone chip protective molding and must be replaced.






1 Stone Chip Protective Molding

• Removing

- Warm the adhesive areas using a hot air gun and remove the stone chip protective molding from the side member in stages.

• The clips are removed from the retaining pins when the stone chip protective molding is pulled off and they must be replaced.

• Installing:

• The side member must be free of dirt and grease in the area with the adhesive strips.

- Bend the removal tabs on the protective film up so they can be reached when the stone chip protective molding is installed on the side member.

- Slide the stone chip protective molding onto the clips as far as the stop working from back to front.

- Note the order for removing the removal tab.

- Press the stone chip protective molding onto the side member in stages.

2 Clip

• Quantity: 9

• The installation direction for the clip is stamped on.

• Slide the clips onto the pins according to the installation direction and engage them.

• Align the clips lengthwise to the side member.

3 Bolts

Removal Tab for Removing Sequence






- Remove the removal tab in the sequence - 1, 2, 3 and 4 -.

- Press the stone chip protective molding onto the side member in stages.