Trim, Sill Side

Trim, Sill Side

Removing

- Remove the bucket seat. Refer to => [ Front Bucket Seat ] Front Bucket Seat.

- Secure the bucket front seat on the fixture for seat repair (VAS 6136). Refer to => [ Front Seat, Installing on the ] Front Seat, Installing on the Fixture For Seat Repair (VAS 6136).

- Remove the outer trim. Refer to => [ Outer Trim ] Outer Trim.

- Remove the seat height adjustment lever. Refer to => [ Seat Height Adjuster ] Seat Height Adjuster.

- Remove the backrest adjustment wheel. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove the left backrest cover => [ Backrest Cover ] Backrest Cover.

- Remove the bolt - 1 -.






- Separate the cable ties.

- Press the retaining tab and pull the electrical connectors out of the brackets.

- Mark electrical connectors - 2 - and - 3 - and remove them.

- Press the locking pin inward and remove the expanding clip - 3 -.






- Release retaining tab - 1 - - arrow A - and remove sill trim - 2 - upward and toward the front - B arrows -,

- Disconnect the lumbar support electrical harness connector.

Installing






Install in reverse order of removal. Note the following:

- Make sure trim - 1 - on the sill side engages correctly in the seat pan and on the backrest - arrows -.

For the correct tightening specifications, refer to:

=> [ Sill and Tunnel Side Trim Overview ] Sill and Tunnel Side Trim Overview,

=> [ Seat Height Adjuster Overview ] Seat Height Adjuster Overview.