Lock, Removing and Installing

Lock, Removing and Installing

• The removal and installation procedure is described on the left lock. Removal and installation is similar on the right lock.

Removing

- Remove the seat bench. Refer to => [ Bench Seat ] Bench Seat.

- Remove the backrest. Refer to => [ Backrest ] Backrest.

- Remove the headrests. Refer to => [ Headrest ] Headrest.

- Remove the cover with the upholstery, refer to:

• => [ Backrest Cover and Padding with Pass-Through ] Backrest Cover and Padding With Pass-Through.

• => [ Cover and Padding, Backrest with Cover or Storage Compartment ] Cover and Padding, Backrest With Cover or Storage Compartment.

- Remove bolts - 3 - (quantity: 2).






- Remove the lock - 2 - from the backrest shell - 1 -.

Locking Mechanism, Version I:






- Detach the cable bracket - 1 - from the locking mechanism - 2 -.

- Detach the nipple on the release cable from the release tab - 3 -.

- Remove the lock.

Locking Mechanism, Version II:






- Remove the support plate - 1 - on the locking mechanism - 2 -.

- Do this by pressing upward - arrow A -, swinging it outward - arrow B -, and removing it in a downward motion - arrow C -.

- Detach the cable bracket - 4 - from the locking mechanism - 3 -.






- Detach the nipple - 1 - on the release cable from the release tab - 2 -.

- Remove the lock.

Installing

Install in reverse order of removal. Note the following:

• The release cable must not be adjusted.

For the correct tightening specifications, refer to => [ Lock Overview ] Lock Overview.