Headlamp Housing

Headlamp Housing

Removing





- Switch off ignition and remove ignition key.

- Turn light switch into 0 position.

- Remove the screws - 1, 2, 3 and 5 -.

- Lift the cover - 4 - on the lock carrier - arrow - and engage it on the radiator grille.

- Disconnect the electrical connector - 4 -.





- Remove the screws - 2 - and - 5 -.

- Loosen the lower bolt - 3 - on the headlamp housing using a long wrench.

• Ignore items - 6 and 7 -.

- Remove headlamp - 1 - toward front from body.

Installing





• Tightening specification, refer to => [ Halogen Headlamps Assembly Overview, through 10.08 ] Halogen Headlamps Assembly Overview, Through 10.08.

Install in reverse order of removal, observing the following:

- When inserting the headlamp - 2 - into the mount - 1 -, make sure the guide tracks on the headlamp engage in the guides on the mount - arrows -.

• Headlamp must slide gently into mount and without using force.

- When sliding the headlamp - 4 - in, make sure the headlamp ventilation - 3 - slides evenly into the mount - 2 - for the ventilation hose - 1 - - arrow -.





- Tighten the screws - 2, 3 and 5 -.