Upper Transverse Link

Upper Transverse Link

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1332)

• Due to the inaccessibility of the inner threaded connection - 1 -, the upper control arm can only be removed when the subframe has been removed.






Removing






- Determine dimension - a - from the center of the wheel to the lower edge of the wheel housing before starting work while the vehicle is resting on its wheels.

- Place the vehicle on a hoist.

- Remove wheels.

- Remove subframe on vehicles with front-wheel drive (FWD). Refer to => [ Subframe with Attachments ] Subframe With Attachments.

- Remove subframe on vehicles with all-wheel drive (AWD). Refer to => [ Subframe with Attachments ] Subframe With Attachments.

- Mark the position of the eccentric bolt - 2 - the wheel bearing housing, for example using a felt-tip pen.






- Separate connections - 1 - and - 2 -.

- Remove upper transverse link - 3 -.

Installing

• Replace the bolts and the self-locking nuts.

Installation position of the transverse link to the subframe

- Install the upper transverse link - 3 - on the threaded connection - 1 - by hand.






- Lay a ruler or straight edge - 1 - flat against the upper transverse link - arrows -.






- Position the upper transverse link - 2 - so dimension a = 8 mm ± 1 mm between the straight edge - 1 - and the stamping burr on the upper transverse link - 2 -.

- Tighten the upper transverse link - 3 - on the subframe in this position.






- Screw wheel bearing housing on control arm and tighten new nut to 20 Nm. Note the installation position of the centering washer - 2 -.

- Install subframe on vehicles with front-wheel drive (FWD). Refer to => [ Subframe with Attachments ] Subframe With Attachments.

- Install subframe on vehicles with all-wheel drive (AWD). Refer to => [ Subframe with Attachments ] Subframe With Attachments.

- Loosen the threaded connection - 1 -.






- Lift the wheel bearing hub into curb weight position. Refer to => [ Wheel Bearing with Coil Spring, Lifting to Curb Weight Position ] Rear Suspension and tighten the threaded connection - 1 -.

Tightening specifications, refer to => [ Upper Transverse Link, Tie Rod, Coil Spring, Lower Control Arm and Level Control System Sensor Overview ] Upper Transverse Link, Tie Rod, Coil Spring, Lower Control Arm and Level Control System Sensor Overview.

- Tighten wheel.

- Perform a wheel alignment. Refer to => [ Wheel Alignment ] Wheel Alignment.

• The wheel alignment must be performed on a VW/Audi approved alignment stand.