0B2A Manual Transmission

Center Differential Housing and Center Differential Assembly Overview

• Removal can also be performed with the transmission still installed.





1 Center Differential Housing

• With or without vibration dampener, depending on version

• Removing and installing, refer to => [ Transmission, Assembly Sequence ] Transmission, Assembly Sequence

• For servicing, refer to => [ Center Differential Housing ] Center Differential Housing

2 Bolt

• Always replace

• 10 Nm plus an additional 90° turn

• Aluminum bolts (M8; 35 mm long)

• Qty. 9 or 11

3 Double Bolt

• Always replace

• 15 Nm plus an additional 90° turn

• Steel bolts (M8/M8; 38 mm long)

• Quantity: 2

• Not installed on all versions

4 Bolt

• Always replace

• 15 Nm plus an additional 90° turn

• Steel bolts (M8; 55 mm long)

• Quantity: 2

5 Spring

6 Plate Spring

• Installed position: The camber on the inner diameter faces the center differential housing

7 Adjustment Shim

8 Center Differential

• Service by manufacturer only

• Center differential bearing, servicing, refer to => [ Spur Gear and Center Differential Bearing, Servicing ] Spur Gear and Center Differential Bearing, Servicing

9 Adjustment Shim

• For positioning the center differential

• Determining thickness, refer to => [ Adjusting Shim S for Positioning Center Differential, Determining ] Adjusting Shim S6 For Positioning Center Differential, Determining

10 Spacer Sleeve

11 End Shield

• Pay attention to the installed position to the transmission cover => [ Install the gear carrier on the transmission cover as follows: ] Transmission, Assembly Sequence

12 Spur Gear

• Side shaft/pinion drive wheel

13 Transmission Cover / Transmission