Flush-Bonded Windows

Flush-Bonded Windows

Special tools, testers and auxiliary items required

• Cutting Tool Kit (VAS 6452)

• Wire Spool (VAS 6452/1)

• Cutting Tool Kit Wire (VAS 6452/2)

• Cutting Tools for Glass (V.A.G 1351)

• Pull Handle (V.A.G 1351/1)

• Suction Lifter (V.A.G 1344)

• Window Cutter (V.A.G 1561A)

• Angled Blade (V.A.G 1561/10)

• Universal Blade (V.A.G 1561/11)

• Scraper (15+25 mm) (V.A.G 1561/7+8)

• Double Cartridge Gun (VAS 5237)

• Cartridge Gun (V.A.G 1628)

• Cartridge Heater (V.A.G 1939A)

Minimum Curing Time

• For safety reasons, use only electrically non-conductive 2C-adhesive when installing windshield and rear window using the materials listed below.

• The vehicle can only be used after the minimum curing time has elapsed.






Adhesive Sealant, Removing from Window

Using adhesive remover (D 002 000 10) is recommended. Always follow the safety precautions when using adhesive remover.

When cleaning from vehicle interior out, the window just installed must not be pressed outward.

Paint Surfaces

- Clean the painted surface with a dry cloth. Clean off any dirt with adhesive remover (D 002 000 10).

Plastic Trim

- Let the adhesive sealant harden (approximately 1 hour) and then peel it off.