Front Doors, Door Components and Central Locking System

Central Locking

=> [ Front and Rear Door Control Module Installation Position ]

=> [ Fuel Tank Lid Unlock Motor ]

=> [ Comfort System Central Control Module ]

Front and Rear Door Control Module Installation Position

Front door control module installation position





- To install, insert door control module - 1 - in lower mounting points, swivel upward and engage.

- Window regulator motor- 2 -.

Rear door control module installation position





- To install, insert door control module - 1 -in lower mounting points, swivel upward and engage.

Fuel Tank Lid Unlock Motor

Remove Fuel Tank Lid Unlock Motor - V155 -





1 Motor for fuel filler door release

• Side trim on right side of luggage compartment removed.

- Disconnect electrical harness connector to motor.

- Loosen bolts - arrow - turning toward right using socket wrench (T10010) and slide motor- 1 - out of oblong holes.

- Before installing new motor, you must first slide emergency release eye- 4 -over locking pin.

• For easier installation, slide an appropriate hose - 5 -from outside to inside as an assisting tool in luggage compartment.

• Place hose - 5 -on operating rod- 4 - and pull outward in tank cup.

- Slide motor into oblong holes and tighten screws to 2 Nm by turning to left

2 Locking clamp

3 Operating rod

4 Cable for emergency release

- Window regulator motor- 2 -.

Comfort System Central Control Module

Location: At right in luggage compartment.

Removing

- If the control module is replaced, select respective module in " Guided Functions".

- Switch off ignition and remove ignition key.

- Remove right luggage compartment side trim panel.

- Release retaining springs - A arrows - and remove Comfort System Central Control Module (J393) downward out of relay and fuse carrier - arrow B -.





- Release securing clip on connector - 1 - and remove.

- Disconnect the connectors - 2 - and - 3 -.

Installation

To install, perform the steps used in removal in reverse order.