Right Engine Mount

Right Engine Mount

Special tools, testers and auxiliary items required

• Engine support bridge (10 - 222 A)

• Engine Support Basic Set (T40091)

• Engine Support Supplement Set (T40093)

Removing

• During installation, all cable ties must be re-installed at the same location.

- Pull rear engine cover - arrows - off.





- Remove rubber seal - 1 - and remove plenum chamber cover - 2 -.





- Remove bolts - arrows -.





- Remove air duct - 1 and 2 -.

- Free up fuel line and line to EVAP canister on air filter housing.





- Disconnect electrical harness connector - 1 - at Mass Air Flow (MAF) Sensor (G70).

- Remove air guide pipe from air filter housing by loosening hose clamps - 5 - and opening clips - arrows -.

• Ignore items - 2, 3, 4 -.

- Open clips - arrows - and remove upper part of air filter housing.





- Disconnect vacuum line - 1 -.





- Remove pin from spreader clips - 4 -.

- Remove lower part of air filter housing and, on the backside, separate electrical connection - 2 - at intake air switch-over valve (N335).

- Remove secondary air injection air guide hose - 3 - by pressing release buttons.

- Secure Adapter (10 - 222 A /4) with connector (T40091/3) and supports (T40093/1) and (T40093/2) to suspension strut towers.





• Support for left and right side of vehicle is marked.

- Install additional Engine Support Bridge (10 - 222 A) parts as shown in illustration. Position supports (T40093/3) on long member notches.





- Engage Hook (10 - 222 A /10) in left engine lifting eye.

- Tension engine with spindle.

- Remove right front wheel.

- Remove sound insulation by loosening securing pieces - 1, 2, arrow -.





- Remove bolts - 1 and 2 - for left and right stabilizer bar mount.





- Slightly lower stabilizer bar.

- Free up electrical wires on right engine mount plate.





- Remove nut - 3 -.

- Remove bolts - 1 and 2 - and remove right engine mount plate.

- Disconnect electrical harness connector - 1 - at right engine mount.





- Remove bolts - arrows - and remove engine support with engine mount.

- Remove nut - arrow - and remove engine mount from engine support.





Installing

• Tightening Specifications => [ Assembly Mount, Overview ] Assembly Mount, Overview.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to torque.

• During installation, all cable ties must be re-installed at the same location.

- Install stabilizer bar.