Instrument Cluster Trim

Instrument Panel

Instrument Cluster Trim

Removing





- Position the steering wheel so that it is as far rearward and down as possible, using the full adjustment range of the steering column adjuster.

- Switch off ignition and remove ignition key.

- Carefully disengage decorative panel - 1 - from instrument panel using trim removal wedge (3409) - arrows -.

- Open coin tray.





- Slide coin tray panel toward the left out of catch - arrow - and remove.

- Open glove compartment.





- Carefully disengage decorative panel - 1 - with switch strip - starting above the glove compartment - from instrument panel using trim removal wedge (3409).

- Pull off decorative panel with switch strip in - direction of arrow -.

• Be especially careful when releasing clip on the driver's side end of decorative panel.

- Disconnect electrical connector.

- Turn knurled wheel - 3 - for left air vent next to instrument cluster completely upward.





- Insert one watchmaker's screwdriver each - 1 - into air vent retaining clamps above the lower ventilation fin - 2 -.

- Pull air vent alternating on left and right side out of the installation opening, watchmaker's screwdrivers must remain inserted while doing this.

• Pull air vent out of installation opening using Hook (3438) if necessary.

- Disconnect electrical harness connector at air vent.

- Repeat the procedure on the right air outlet near the instrument cluster.

- Remove bolts - arrows -.





• Secure a cloth with adhesive tape to protect the steering column trim and the steering column lever.

- Pull the instrument panel cover away from the instrument cluster slightly.

- Disconnect the electrical connectors on the instrument cluster cover.

- Engage the turn signal switch in the bottom switch position.

- Activate the one-touch wiping and hold the instrument panel cover in this wiper switch position.

Installing

Installation is reverse of removal.

Tightening torque:

Instrument cluster/instrument cluster cover to instrument panel: 3 Nm